2-5 Using ZOOM and PAN

You cannot view this unit as you're not logged in yet.

admin2020-11-17T15:48:47+08:00

Module 1	1. The Interface	+
. 1	1-1 The application menu
. 2	1-2 The ribbon and panels
. 3	1-3 Dialog boxes and palettes
. 4	1-4 The status bar
Module 2	2. Drawing Simple Geometry	-
. 1	2-1 OSNAP (object snap) and OTRACK (object snap tracking)
. 2	2-2 POLAR (polar tracking) and ORTHO (orthogonal mode)
. 3	2-3 Lines, arcs, and circles
. 4	2-4 Polylines, polygons, and splines
. 5	2-5 Using ZOOM and PAN
Module 3	3. Annotating Simple Designs	+
. 1	3-1 Text styles
. 2	3-2 Single line text (TEXT) and multiline text (MTEXT)
. 3	3-3 Dimension styles
. 4	3-4 Placing dimensions
. 5	3-5_Adding a simple table
Module 4	4. Communicationg Your Design Intent	+
. 1	4-1 Creating a simple title block
. 2	4-2 Defining your page setup
. 3	4-3 Adding new layouts and scaled viewports
. 4	4-4 Using annotative scaling
. 5	4-5 Printing and plotting
. 6	⇢ 4-5-1 tips and tricks : Configuring GstarCAD plot drivers